03-09 Nissan 350z Neopixel Acrylic LED Panels (Turn Signal/Reverse Housing)

THIS IS A DIY ITEM, NOT PREBUILT.

Laser-cut acrylic LED panels designed to drop into the turn signal/reverse section of the 03-09 Nissan 350Z rear housing. Cut from high-quality acrylic to fit the factory housings exactly — no trimming or modification required. Designed for use with 5mm LEDs.

Choose your configuration

• Bare Acrylics — Just the laser-cut panels. Bring your own LEDs and wiring.
• Acrylics with RGB Neopixel LEDs — Laser-cut panels plus a matching set of loose 5mm RGB Neopixel LEDs (WS2812). You install and solder them yourself. When wired to the BlueGhozt Lite Smart LED Controller or any WS2812-compatible module, you get fully addressable, app-controllable color and animation.

What's Included

• 1x Pair of laser-cut acrylic panels (driver + passenger side)
• Set of loose 5mm RGB Neopixel LEDs (only on the “Acrylics with RGB Neopixel LEDs” variant — LEDs are NOT pre-installed)
• Pre-drilled holes ready for 5mm LEDs
• Compatibility-tested for the 03-09 Nissan 350Z taillight housing

What's Not Included

• LEDs (unless you select the “Acrylics with RGB Neopixel LEDs” variant)
• Controller (use any WS2812-compatible driver, BlueGhozt Lite recommended)
• Power supply / wiring harness
• Solder, flux, hookup wire, and other consumables
• Installation labor, you do all the soldering

Features

• Laser-cut precision: Engineered to match factory housing dimensions exactly
• Designed for 5mm LEDs: Pre-drilled to fit standard 5mm through-hole LEDs
• RGB Neopixel option: Loose WS2812 5mm LEDs can be added as an upgrade variant. You solder them in yourself for fully addressable color and animation.
• DIY-friendly: Designed for enthusiasts comfortable with soldering and basic wiring
• Drop-in fit: No housing modifications needed
• Pairs with BlueGhozt Lite: Use any WS2812 / SK6812-compatible controller when going RGB

Compatibility

• Nissan 350Z: 2003-2009 (Z33 chassis, all trims)
• Section: Turn signal and reverse light area of the OEM tail light housing
• LED type (RGB variant): 5mm RGB Neopixel (WS2812 protocol)

Installation

This is a DIY product intended for enthusiasts comfortable with soldering and wiring. For either variant, you'll need to:

1. Insert your LEDs (either the included Neopixels or your own 5mm LEDs) into the pre-drilled holes on the acrylic panel.
2. Solder the LED leads to the solder pads on the back of the panel.
3. Run power and data lines from your controller to the panel.
4. Mount the panel inside your tail light housing.

Basic soldering iron, flux, and hookup wire required. Plan ~1-2 hours per side if you're comfortable with soldering.

Important Notes

• Off-road use only. All light modifications are intended for off-road use only. Please refer to your local laws and regulations before using on public roads. We are not liable for any damages caused by installation or use of this product.
• No returns on installed items. Once panels have been soldered, modified, or installed, they cannot be returned or refunded.
• LED warranty: Included Neopixel LEDs are warrantied dead-on-arrival only. Once you solder them, warranty is void (damage from incorrect wiring, over-voltage, heat, or soldering errors is not covered).
• Acrylic panel warranty: 1-year warranty on manufacturing defects of the laser-cut panels themselves.